ABSTRACT Background 2‐octyl‐cyanoacrylate‐mesh‐systems are used as topical wound closure devices in surgery and are increasingly associated with allergic and irritant contact dermatitis. Formaldehyde, a degradation byproduct of cyanoacrylates and a potent sensitiser, is believed to be associated with this reaction, but emission levels have not been quantified. Methods A bench microchamber study was performed using standardised 4 × 4 cm polyester mesh with applied 2‐octyl cyanoacrylate adhesive in a 30 L chamber (25°C, 1 atm, 1 h −1 air exchange). Formaldehyde off‐gassing was captured with DNPH cartridges (NIOSH 2016) and quantified via HPLC‐UV over 2 h. Data were upscaled to simulate clinical use and projected to 14 days under constant‐flux and flux‐halving scenarios. Results Dermal loads at 14 days reached 8.4 μg/cm 2 , over eight times the EPA 1 μg/cm 2 benchmark and above the 4.5–7.5 μg/cm 2 elicitation range reported in formaldehyde‐sensitive patients. Under flux‐halving conditions, dermal exposure remained at 4.8 μg/cm 2 , nearly five times the EPA benchmark and above the elicitation threshold. Mean 2‐h airborne concentrations of 0.020–0.0385 ppm exceeded the NIOSH limit of 0.016 ppm by approximately 1.25–2.41‐fold. Conclusion 2‐octyl‐cyanoacrylate‐mesh‐systems emit formaldehyde at levels exceeding sensitization and inhalation thresholds, raising concern for dermal and respiratory exposure, particularly in sensitised individuals. Prior sensitisation from adhesives such as nail, eyelash or super glues may heighten risk.
Rouhani et al. (Mon,) studied this question.