The impact of minor manufacturing deviations in facesheet orifice geometries on the acoustic impedance of liners is studied. Using the lattice-Boltzmann method, simulations of a normal impedance tube (NIT) with plane acoustic waves at sound pressure levels of 130 and 145 dB and frequencies of 800, 1400, and 2000 Hz were performed. Experimental validation was conducted at the Federal University of Santa Catarina using a baseline geometry obtained via 3D scanning and characterized by rounded orifice edges. This geometry was modified to investigate the influence of various edge configurations: sharp edges, double chamfers, and single top chamfers. Results show that sharp-edged orifices increase acoustic resistance and absorption, while geometries with rounded or chamfered edges reduce resistance by up to 28% and lower the absorption coefficient. This is similar to what was found experimentally by performing NIT measurements over different parts of the liner sample. Velocity field analysis reveals that flow separation at the orifice edge is the primary mechanism driving impedance variation, independent of frequency or sound pressure level. These findings underscore the significant influence of small geometric imperfections, often introduced during manufacturing, on liner performance, highlighting the need to consider such variations in industrial design and quality assurance processes.
Avallone et al. (Tue,) studied this question.