In metal forming, thermoelectric currents, arising from differences in the Seebeck coefficient between the tool and workpiece, can critically promote adhesive wear (galling) at their interface. In this study, tailored coatings deposited via extreme high-speed laser material deposition (EHLA) were used to locally tune the Seebeck coefficient and modulate this thermoelectric behavior. Shear cutting experiments under single- and continuous-stroke conditions, with and without lubrication, showed a strong correlation between local current flow and adhesion onset.Validation via dry deep drawing in single-stroke mode confirmed the reduction in adhesion. Coatings engineered for defined thermoelectric potential gradients significantly reduced adhesion-driven material transfer in aluminum sheet metal processing. However, the approach was less effective for stainless steel due to abrasive wear and limited coating hardness. Thermal simulations indicate the required coating thickness to maintain substrate temperatures below critical thresholds even under severe thermal loads. EHLA coatings with thicknesses of 500–1000 µm were experimentally validated to achieve this. Developed analytical and machine-learning models based on chemical composition predict the Seebeck coefficient of multi-component alloys, complementing the estimation of thermoelectric behavior and guiding the experimental design of EHLA coatings. The results substantiate thermoelectric-aware coating design as an effective strategy to mitigate adhesive wear in metal forming tools. • Thermoelectric currents identified as a major source of adhesion in metal forming like shear cutting or deep drawing. • Fe-based EHLA coatings with tailored nickel or silicon contents enable local adjustment of the Seebeck coefficient at tool surfaces. • Single- and continuous-stroke shear cutting experiments demonstrate up to 95 % reduction in adhesive wear and galling. • Coatings thicker than 500 µm, preferably 1000 µm or more, effectively suppress flash-induced currents. • Deep drawing experiments validate the reduction of adhesion driven by thermoelectric effects.
Prüfer et al. (Sun,) studied this question.