What question did this study set out to answer?

The study aims to create a low-cost capacitive sensor for accurate soil water content estimation using 3D printing.

February 28, 2026Open Access

Development of a 3D-Printed Capacitive Sensor for Soil Water Content Estimation Using Nickel-Based Conductive Paint

Key Points

The study aims to create a low-cost capacitive sensor for accurate soil water content estimation using 3D printing.
Developed a capacitive sensor using nickel-based conductive paint applied to 3D-printed electrodes.
Conducted rigorous testing including calibration and validation under controlled laboratory conditions.
Compared the sensor's performance with the time-domain reflectometry (TDR) method, a standard for soil moisture measurement.
The capacitive sensor demonstrated good reliability in measuring volumetric water content within the range of 0 to 0.40 cm3/cm3.
Effective performance was confirmed through comparison with TDR, showcasing the sensor's accuracy and robustness.

Abstract

Understanding hydrological, agricultural, and environmental processes in soils relies on accurately measuring volumetric water content (θ), matric potential (h), and hydraulic conductivity (K). These parameters are fundamental for quantifying plant-available water, optimizing irrigation scheduling in precision agriculture, modeling watershed responses, and studying the impacts of climate change in complex ecosystems. Among these parameters, θ is truly indispensable, as it represents the primary indicator of the water status of soils and a prerequisite for interpreting the other hydraulic variables. In recent years, capacitive sensors have become one of the most widely adopted technologies for θ estimation, owing to their favorable balance between accuracy, robustness, and affordability. These sensors infer soil moisture by measuring dielectric permittivity of soils, which is strongly governed by water content, making them particularly suitable for distributed monitoring and IoT-based environmental applications. The present study aimed to develop a low-cost capacitive sensor for θ estimation. This sensor can be made using 3D printing technology combined with conductive, nickel-based paint, which (once applied on the 3D-printed guides) forms the capacitive electrode. The capacitive component operates at an operational frequency of 60 MHz. The system was subjected to a rigorous testing protocol, including calibration and validation phases under laboratory conditions using three soils of different textures. Its performance was specifically compared with the time-domain reflectometry (TDR) technique, which is widely recognized in Soil Physics and Soil Hydrology as the reference method for θ estimation due to its reliability and accuracy. These tests confirmed the effective performance of the proposed sensor, which overall exhibited good reliability within the selected validation range, corresponding to a θ range of 0 to 0.40 cm3/cm3.

Read Full Paperexternally

AIに質問

Bookmark

View Full Paper