• Magnetron-sputtered Pt/Ti model films are employed to mimic porous transport layers in PEMWE. • The Pt-coating thickness required to suppress Ti degradation is systematically evaluated. • Operando SFC-ICP-MS quantifies Pt and Ti dissolution under different electrochemical protocols. • Fluoride impurities significantly accelerate degradation, reinforcing the need for robust Pt coatings. Platinum-coated titanium porous transport layers (PTLs) are commonly used in proton exchange membrane water electrolyzers (PEMWE) to ensure electrical contact and corrosion resistance on the anode side. While the impact of platinum on interfacial performance has been extensively studied, the effect of Pt coating thickness on dissolution stability is still not well understood. In this study, model Pt/Ti thin films with tuned Pt thicknesses ranging from 1 to 100 nm are fabricated using magnetron sputtering. The films are examined using operando scanning flow cell inductively coupled plasma mass spectrometry (SFC-ICP-MS). Our findings reveal that thin Pt coatings do not block Ti dissolution under the tested conditions, while coatings of 20 nm or thicker substantially suppress Ti dissolution under specific dynamic operating protocols. In fluoride-containing electrolytes, the most robust and consistent suppression of Ti dissolution across all investigated conditions is achieved with 100 nm Pt coating. These results highlight critical Pt thickness thresholds necessary to suppress Ti corrosion under the operating conditions investigated here and provide a mechanistic foundation for the rational design of PTL coatings prior to validation at the device level.
Silva et al. (Sun,) studied this question.