Disk-type electromagnetic direct-drive centrifugal pumps have broad application prospects in fluid transport due to their compact structure and seal-free design. However, the significant axial force caused by pressure imbalances on both sides of the impeller severely affects the operational stability and the service life of the pump. This study selected the IS50-32-160 pump as the research object, seeking to optimize various balance hole structures for reducing axial force and enhancing pump efficiency. Using ANSYS-ICEM 2022 for hydrodynamic performance mesh generation and Fluent for numerical simulations, we systematically analysed 24 balance hole models with varying diameters, lengths and aperture gradient profiles to evaluate their effects on pump hydrodynamic performance, motor air-gap pressure, leakage rate and axial force. The results demonstrate that the balance hole diameter predominantly affects axial thrust, whereas the length exhibits negligible influence. Specifically, when the diameter was increased from 0 to 8 mm, the axial force dropped sharply, from 703.45 N to 125.57 N. The most pronounced reduction, of 54.7%, occurred within the 3 to 5 mm diameter range, after which the decline rate significantly slowed. In contrast, increasing the length from 84 to 100 mm only caused a marginal 4.08% rise in axial force, from 307.22 N to 320.30 N. The diverging balance holes, characterized by a linear diameter expansion from the shaft end toward the impeller side, achieved continuous and stable pressure distribution. This design not only effectively mitigated axial force but also prevented abrupt pressure fluctuations at the shaft end. The study confirms the feasibility of improving pump performance through balance hole optimization and provides a theoretical foundation for designing disk-type electromagnetic direct-drive centrifugal pumps.
Wang et al. (Mon,) studied this question.