Composite bone replicas are widely used in biomechanical testing as alternatives to cadaveric specimens, with numerical models often complementing or replacing experiments. The reliability of these models depends strongly on accurate material parameters. This study investigates a fourth-generation Sawbones composite L5 vertebra, updating cortical material properties under isotropic and transversely isotropic modelling assumptions. Finite element models were calibrated using free-free experimental modal analysis, revealing differences between manufacturer-provided material properties and the measured specimen behaviour. For both models, matching the specimen mass required reducing the cortical density from 1.64 g/cm3 to 1.423 g/cm3. In the isotropic model, the Young’s modulus was reduced from 16,000 MPa to 6500 MPa. In the transversely isotropic model, longitudinal and transverse Young’s moduli were reduced from 16,000 MPa and 11,000 MPa to 6400 MPa and 5500 MPa, respectively, while the shear moduli decreased from 4370 MPa and 6350 MPa to 3500 MPa and 2540 MPa. In both models, the Poisson’s ratio was increased from 0.26 to 0.30. These updates reduced the average eigenfrequency error to 6.12% (isotropic) and 5.83% (transversely isotropic), with the first five modes errors reduced to 3.10% and 2.80%, respectively, substantially improving numerical representation of L5 vertebral mechanics. The updated vertebral FE model and accompanying workflow enhance the reliability of future FE analyses, improve interpretation of Sawbones vertebra biomechanical results, and support vibration-based biomechanical applications such as implant fixation assessment.
Bogaert et al. (Tue,) studied this question.