Non-destructive and destructive test methods are applied to wood to characterize this heterogeneous natural material. There have been multiple studies to characterize and investigate the change after the treatment (impregnation, thermal modification, etc.). In terms of thermal modification, there have been few studies on thermo–vacuum treatment, which is performed in a continuous vacuum atmosphere. With this method, the objective was to attempt to reduce the strength decrease after the thermal treatment. The aim of this study was to estimate the flexural properties of thermo–vacuum-treated Scots pine wood with destructive and acoustic-based non-destructive test methods. Wood was treated at 180 °C and 360 mm Hg. Both treated and untreated samples were cut into small specimens to ensure they were free of defects and were tested with acoustic-based non-destructive (longitudinal vibration and stress wave) and static bending test methods. The results show a decrease in equilibrium moisture content, demonstrating the efficiency of the treatment. When the results were compared with destructive test results, higher correlations (R2 > 0.858) were found when estimating the modulus of elasticity (MOE) for both the untreated and treated wood, while lower correlations (R2 0.8986) were obtained between the non-destructive and destructive test results.
Hızır Volkan Görgün (Fri,) studied this question.