Rock bursts frequently occur in the fault group area in China, seriously restricting the safe and efficient production of coal mines. Based on field investigation, physical experiments, and numerical simulation, this study investigates the rupture types and spatial evolution of microseismic events during the excavation of working face through fault group areas in the TB Coal Mine, where the hard roof asymmetric is cut by faults. It reveals the cooperative instability mechanism of faults and hard roof, as well as the mechanisms of rock burst. Targeted rock burst prevention measures are proposed, including “roof blasting to cut off dynamic and static load transfer” and “coal blasting to reduce abutment stress”. The results demonstrate the following: (1) during mining in fault group areas, the synchronous activation of faults induces shear-type and high-energy microseismic events and the subsequent movement of hard roof, which has been cut by faults, forms asymmetric parallelograms and symmetric inverted trapezoids, and induces tensile-type and high-energy microseismic events. The synchronous activation of faults and the breaking of the hard roof are identified as the primary reason for high-energy microseismic events. (2) As the fault dip angle approaches 90º, the compressive strength of the fault-segmented hard roof strata decreases. Under synchronous activation of faults, roof failure concentrates in the central, right, and left sections for fault combinations with dip angles of 70° + 70°, 90° + 70°, and 110° + 70°, respectively. (3) Numerical simulations reveal two rock burst mechanisms in faults—hard roof systems: a forward “high dynamic stress and high static stress” type and a rear “low dynamic stress and high static stress “ type, which is consistent with in situ monitoring data. (4) For the three stages in which the 502 working face approaches, passes through, and mines away from the fault group area, a stress relief scheme combining roof blasting and coal blasting is proposed. Compared with the 501 working face, during the mining of the 502 working face, the total microseismic frequency and energy decreased by 71.9% and 87.9%, respectively, and the effectiveness of these measures is verified.
Guo et al. (Mon,) studied this question.