The increasing operational variability in distribution networks (e.g., abrupt load changes and distributed generation integration) increases the demands on voltage regulation devices and, in particular, on transformers with on-load tap changers (OLTCs). This paper develops and validates a discrete supervisory control scheme based on Petri nets, implemented in Stateflow and coupled to an electromagnetic model of the OLTC transformer in Simulink/Simscape. The Petri net formalizes the conditional and sequential logic of OLTC operation, enabling state- and time-dependent decisions (e.g., delays between maneuvers) to improve voltage regulation and reduce unnecessary tap operations. The evaluation is performed by simulation under transient scenarios that include sudden load variations anda phase-to-ground fault in the IEEE 13-node standard network, specifically at node 634. In the base case, the controller maintains the voltage within the tolerance band ±1.875% during 96% of the simulated time, with an 88% reduction in RMS error (from 1.92% to 0.23%) and 100% operational efficiency (16 effective maneuvers, with a single hunting event). Subsequently, the scheme is validated on the standard IEEE 13-node network, with four disturbances applied over 600 s (two load increments, photovoltaic injection, and a temporary line disconnection). In this case, regulation remains within a precision zone of ±0.3% for 96.8% of the time, with an average RMS error of 0.23% and 100% efficiency, with no hunting events. The results confirm that a Petri net-based supervisory logic can simultaneously improve the OLTC’s voltage quality and switching efficiency, providing a reproducible alternative for distribution network automation.
Montenegro et al. (Fri,) studied this question.