The present work investigated the thermodynamic behaviors of oxygen in a liquid Fe–Ti alloy over a wide Ti concentration range of 11.6–71.2 wt% at 1873 K by integrating equilibrium experiments with thermodynamic modeling. To prevent excessive oxidation during the equilibrium experiments, the liquid alloys were equilibrated in a purified Ar atmosphere with an oxygen partial pressure below ~10−20 atm. Two quenching methods—furnace quenching with He gas injection and water quenching via quartz tube suction—were employed to evaluate the effect of cooling rate on total oxygen measurements. While He gas quenching led to higher measured oxygen contents owing to the formation of secondary Ti oxides, the quartz tube suction quenching method consistently yielded significantly lower oxygen values. The dissolved oxygen content increased with increasing Ti content. Electron probe microanalysis identified TiO as a stable equilibrium oxide phase above 11.6 wt% Ti, which was characterized as a face-centered cubic (FCC) rock-salt structure via electron backscatter diffraction analysis. Based on these results, a thermodynamic assessment of oxygen behavior in a liquid Fe–Ti alloy in equilibrium with TiO was performed for the first time using a modified quasichemical model. Consequently, the present model successfully reproduced the Ti–O relationship in the liquid Fe–Ti alloy across both the high-Ti concentration region saturated with TiO and the low-Ti concentration region saturated with Ti2O3 and Ti3O5.
Kim et al. (Mon,) studied this question.