Sometimes only a portion of the surface of a concrete element is loaded, which causes stress concentration in that region. To safely transfer concentric loads to concrete components such as column bases, short cantilevers, superstructure piers, post-tensioned elements, and support anchors, it is imperative to investigate the local compressive characteristics of concrete. To learn more about this subject, further research is required, as there are currently insufficient studies in this field. Therefore, the local compressive behavior of concrete under concentric stresses is the main focus of this work. Concrete is represented as block samples with dimensions of 200 × 200 × 250 mm. A stiff steel plate is used to apply concentric loading on the surface of the samples. The primary parameters are the bearing plate dimensions, shape (square, rectangle, and circular with varying areas), and rectangularity. Additionally, the bearing plate’s movement is examined. The stress-slip curves, ultimate bearing strengths, failures, and related slippages of the tested samples are discussed. The findings revealed that the upper surface of the concrete samples exhibited localized deterioration beneath the bearing plate. Additionally, the ultimate bearing strength of the sample loaded with the 6 × 6 cm square plate was 163% greater than that of the sample loaded with the 10 × 10 cm square plate. Furthermore, the sample loaded with the circular plate with a diameter of 4 cm had an ultimate bearing strength that was 181% greater than the sample loaded with the circular plate with a diameter of 11 cm. It is clear that the samples loaded with a circular plate of varying diameters had an ultimate bearing strength that was 8.5–11% higher than the samples loaded with a square plate of varying lengths.
Fayed et al. (Sun,) studied this question.