This study investigates how key milling parameters influence both cutting noise and surface quality during the machining of laminated bamboo lumber. Using a multifactorial optimal response surface methodology, the effects of fibre orientation (0–135°), spindle speed (7000–10,000 r/min), feed rate (0.5–2.0 m/min) and milling depth (0.5–2.0 mm) were quantified through 25 experimental runs. Cutting noise, measured as peak sound pressure level (SPL), ranged from 86.8 to 95.2 dB, increasing markedly with fibre angle, feed rate, and milling depth, but exhibiting a non-linear response to spindle speed. Surface roughness (Sa) varied from 2.6 to 11.7 µm and was most strongly governed by milling depth, followed by fibre orientation and feed rate, with a significant interaction between fibre orientation and spindle speed. Quadratic regression models demonstrated strong predictive performance (R2 = 0.97 for SPL; R2 = 0.85 for Sa). Based on the response surfaces, optimal low-noise, high-quality machining was achieved at moderate spindle speeds, low feed rates, and shallow milling depths. These findings provide a mechanistic basis for understanding noise–roughness coupling in bamboo machining and offer practical guidance for computer numerical control processing, tool selection, and industrial noise reduction strategies in bamboo manufacturing.
Chen et al. (Fri,) studied this question.