A conformal SiNx coating on carbon nanotubes (CNTs) was achieved by combining transient UV–ozone surface functionalization with a two-step atomic layer deposition (ALD) process. UV–ozone treatment gradually increased the defect density of CNTs, with the ID/IG ratio increasing from 0.05 for pristine CNTs to 0.25 after 7 min of exposure, while the overall fibrous CNT network remained intact. However, prolonged UV–ozone exposure beyond 10 min led to a sharp increase in the ID/IG ratio to 0.46, accompanied by structural degradation of the CNT membrane. Hydroxyl (-OH), epoxy (C-O-C), and carbonyl (C=O) groups were introduced by UV–ozone treatment and were partially removed during subsequent high-temperature processing. Accordingly, direct high-temperature ALD resulted in incomplete SiNx coverage of the CNTs, suggesting insufficient nucleation. A two-step ALD process, consisting of several cycles of low-temperature nucleation at 100 °C followed by high-temperature growth at 700 °C, enabled more conformal deposition of SiNx on CNTs. In addition, both annealing and ALD reduced the defect level toward that of pristine CNTs, supporting the transient nature of UV–ozone-induced functionalization.
Kang et al. (Thu,) studied this question.