Key points are not available for this paper at this time.
The thermomechanical and viscoelastic properties of a glass fiber polyethylene terephthalate glycol (GF/PETG) continuous unidirectional (UD) tape were investigated using differential scanning calorimetry (DSC), thermomechanical analysis (TMA), and dynamic mechanical analysis (DMA). This study identified five operational conditions based on the Army Regulation 70-38 Standard. The DSC results revealed a glass transition temperature of 78.0 ± 0.3 °C, guiding the selection of temperatures for TMA and DMA tests. TMA provided the coefficient of thermal expansion in three principal directions, consistent with known values for PETG and GF materials. DMA tests, including strain sweep, temperature ramp, frequency sweep, creep, and stress relaxation, defined the material’s linear viscoelastic region and temperature-dependent properties. The frequency sweep indicated an increased modulus with rising frequency, identifying several natural frequency modes. Creep and stress relaxation tests showed time-dependent behavior, with strain increasing under higher loads and stress decreasing over time for all tested input values. Viscoelastic models fitted to the data yielded R2 values of 0.99, demonstrating good agreement. The study successfully measured thermomechanical and viscoelastic properties across various conditions, providing insights into how temperature influences the material’s mechanical response under extreme conditions.
Quintana et al. (2024) studied this question.