Key points are not available for this paper at this time.
Abstract Solar PV has experienced unprecedented growth in the last decade, with the most significant additions being utility-scale solar PV. The role of grid inverters is very critical in feeding power from distributed sources into the grid. With the increasing growth of grid-tied solar PV systems (both rooftop and large-scale), the awareness of power quality issues has risen with new regulations and standards to ensure the stability of the power grid. The power quality of microinverters has been investigated under steady solar irradiation and PV power source and also under real outdoor conditions in compliance with the accepted solar PV integration requirements. The current total harmonic distortion (THD) measured for the studied microinverter under outdoor conditions far exceeded the current THD for the study under steady indoor conditions and was beyond the accepted standard. However, the voltage THD outputs for the two studied cases were in good agreement with the grid codes. The voltage and current THD for the 400 Wm −2 (60 Wp) and the 1000 Wm −2 (146 Wp) scenarios under the steady solar irradiation (solar PV power) were 2.24%, 13%, and 2.27, 6.93%, respectively. The voltage and current THDs for the outdoor study were 2.03% and 14.28% for Solarex (pc-Si module), 1.94%, and 27.43% for Juta (mc-Si modules), and 1.97% and 33.6% for Dunasolar (a-Si glass module). Results showed a strong correlation between the intermittence of solar radiation and the current THD. 67%, 54%, and 37% of the recorded power factor for Dunasolar, Juta, and Solarex modules, respectively, exceeded the limits prescribed by the standards.
Atsu et al. (2024) studied this question.