The recycling of carbon fiber-reinforced polymers (CFRPs), particularly carbon fiber-reinforced epoxy polymers (CFREPs), is a challenging problem because of their broad application spectrum, the amount of laminates produced per year, and the cost per kg of the carbon fiber fabric. Recently, several papers were published on the recycling of CFREPs through solvothermal methods that allow the recovery of the carbon fiber fabrics with a relatively low environmental impact. In the present paper, for the first time, the effect of the presence of flame retardants is discussed. A carbon fiber-reinforced epoxy polymer (CFREP) charged with P-, Zn-, B- and Al-based flame retardants, supplied by the aerospace industry, was subjected to a double-step solvothermal treatment. The epoxy matrix was successfully dissolved in monoethanolammine after a preswelling step in acetic acid. The experimental results show that the proposed process allows the full recovery of the carbon fabric with its original sizing layer without injury to the fiber. As confirmation, CFREP laminates produced with the recycled carbon fiber fabrics exhibited mechanical properties close to that of laminates obtained from the virgin epoxy/carbon prepreg. Contrary to what is reported in the literature, the present paper also shows that, in the studied case, whilst acetic acid treatment promotes swelling, it also causes the formation of a degraded surface layer that would impede complete removal of the polymeric matrix and full recovery of the carbon fabric if only acetic acid was used. On the basis of the known mechanism of flame retardancy of phosphates and borates, the degraded layer formation is attributed to the acidic character of the acetic acid. It is worth pointing out that the paper suggests, therefore, that the presence of flame retardants may strongly affect the solvothermal processes.
Branda et al. (2026) studied this question.