Electrical Resistivity Tomography (ERT) has proven to be a highly sensitive geophysical method for characterizing the dynamics of seawater intrusion. This study uses tank experiments to simulate seawater intrusion, utilizing electrical resistivity tomography to monitor real-time changes in groundwater resistivity during the intrusion process. The objective is to quantitatively reveal the development and evolution mechanisms of seawater intrusion wedges in sandy aquifers, thereby establishing a real-time resistivity monitoring method for groundwater distribution and migration characteristics. This study improves resistivity imaging data processing methods, enhancing both efficiency and accuracy. The refined cross-hole ERT technique is applicable not only to meter-scale indoor experiments; its optimized forward and inverse algorithms can also be directly transferred to regional-scale field monitoring. Experimental results show that the average resistivity in the study area continuously decreases from 57 Ω·m in the initial freshwater state to 1.1 Ω·m at the intrusion stabilization point. Areas with resistivity values below 20 Ω·m corresponded exactly to the brine intrusion zone. The evolution of the freshwater-saltwater interface unfolded in three stages: Initially, the density difference (0.025 g/cm3) dominated, with the saltwater intrusion depth at the aquifer base reaching 0.45 m, significantly exceeding the 0.04 m penetration at the upper section. During the intermediate stage, the interface morphology differentiated into an “upper triangular, lower arc-shaped” configuration. The bottom intrusion distance increased to 1.65 m, and the thickness of the brackish-freshwater mixing zone expanded from 0.1 m to 0.3 m. In the final stage, the interface stabilized and began intruding toward the surface, establishing a new hydrodynamic equilibrium. In addition, the migration rate of saline water at the aquifer base gradually decreased from 6.25 × 10−4 cm/s initially to 1.16 × 10−5 cm/s at steady state. These results reflect the dynamic coupling process between seepage and dispersion and demonstrate that this method enables effective real-time monitoring of seawater intrusion development and conditions, as well as early warning capabilities.
Bu et al. (2026) studied this question.