Reducing the carbon footprint of cement based materials requires approaches beyond replacing cement alone. Mineral carbonation of aggregates offers a simple route to store carbon dioxide permanently while improving material performance. In this study, four steel slag aggregates were evaluated as sand replacements in mortar after pre carbonation, including basic oxygen furnace slag, blast furnace slag, skim slag, and Rockport slag. The aggregates were treated using moisture assisted carbonation with carbon dioxide and then used in mortar made under the same mix design and curing conditions. Bulk chemistry was determined by X-ray fluorescence, carbon uptake was quantified by thermogravimetric analysis, and performance was evaluated using compressive strength, ultrasonic pulse velocity, chemical soundness, freeze thaw resistance, and scanning electron microscopy. Pre-carbonation stored approximately 14–19 wt% CO2 relative to the dry mass of the slag aggregates, depending on slag type. Mortars with carbonated basic oxygen furnace slag and carbonated blast furnace slag showed clear strength gains at 28 days, along with higher ultrasonic pulse velocity and improved chemical durability. Rockport slag showed modest improvement, while skim slag showed a reduction in strength after carbonation. Microstructural observations indicate that carbonate precipitation filled pores and densified the aggregate paste interface, which explains the strength and durability improvements in the more responsive slags. These laboratory-scale results show that, under the specific moisture-assisted pre-carbonation conditions investigated, pre-carbonation of slag aggregates can combine permanent CO2 storage with improved mortar performance. However, the magnitude of these benefits depends strongly on slag chemistry and particle structure, highlighting the need for slag-specific carbonation design and further validation under practical conditions.
Liaqat et al. (Fri,) studied this question.