The removal of excessive amounts of antibiotics from water systems is of great benefit due to their adverse effects on the ecosystems, living organisms and the persistent increase in antibiotic resistance cases. This study was focused on the adsorption of vancomycin from a simulated aqueous medium using seaweed, a sustainable and low-cost adsorbent. Also, the work focuses on assessing the influence of surface modification on adsorption behaviour and determining if chemical treatment provides improvements over untreated seaweed. In particular, chemically modified seaweed and raw (non-modified) seaweed were assessed as adsorbents suitable for removing traces of vancomycin from water, as gauged from the results of High-Performance Liquid Chromatography (HPLC). In addition, Scanning Electron Microscopy (SEM), Fourier Transform Infrared spectroscopy (FT-IR) and the pH point of zero charge (pHpzc) were used to measure the surface characteristics of these adsorbents. The degree of antibiotic adsorption was evaluated as a function of different factors, including the pH, adsorbent dosage, contact time, ionic strength and initial concentration of vancomycin. Thermodynamic parameters, such as the enthalpy change (∆H°), the entropy change (∆S°) and the free-energy change (∆G°), were calculated. The FTIR analysis indicates that functional groups, such as carbonyl and hydroxyl groups, were involved in the adsorption process, and their modification influenced adsorption behaviour. It was observed that the adsorption of vancomycin by the modified seaweed was slightly lower (±94%) compared to the level achieved for the raw seaweed (±97%). These figures were obtained with an initial concentration of vancomycin of 25 µg/mL, a pH of the aqueous solution of 7.0, an adsorbent dose of 0.2 g and a contact time of 120 min. The results showed that untreated seaweed exhibited slightly higher adsorption efficiency than the treated seaweed, suggesting that chemical modification might not have enhanced adsorption performance. The thermodynamic parameters suggested that the adsorption process was exothermic and that adsorption was favourable for the untreated seaweed and less favourable for the treated seaweed. Regeneration studies showed a decrease in adsorption efficiency over repeated cycles. Although the adsorption capacity is lower than that of advanced nanomaterials, the use of seaweed offers an advantage in terms of low cost, availability and environmental sustainability. The comparable efficiency of the modified and untreated seaweed adsorbent suggests that seaweed adsorbents can be used as viable bio-adsorbents for the decontamination of water.
Onyekachukwu et al. (Mon,) studied this question.